Name:
Company:
E-Mail:
Telephone No:
Manufacturer:
Model:
Tag No:
Serial No:
Last UKAS Cert No:
DP Range: mbar
Static/line Pressure: bar (gauge mode)
Orientation: Electronics above process connections and flange Electronics at same level as process connections and flange
Calibration is normally performed at 0, 25, 50, 75, and 100% of the DP range specified above. If these increments yield fractional values e.g. 112.5 mbar and your footprint test equipment only has a minimum 5 mbar increment we can round these points accordingly.
Round calibration points to the nearest: mbar
Are as found results required? Yes No
Is pre-calibration conditioning required?(Exercise 3 cycles 0% to %)(Default is 3 x 0% to 125%) Yes No
Please state the maximum value for pressure conditioning i.e. 100%, 125% of range; if this transmitter is the low range device in a multi-transmitter system this value could be 100% value of the highest range transmitter in the system. %
Is the output to be measured from the digital or analogue data? Digital Analogue
If analogue output measurement is required, specify which electrical quantity Volts Amps
What value of resistor if the output is volts measured across a resistor? Ω
The transmitter power supply will normally be set at 24 vdc with a minimum current loop impedance of 300 Ω in circuit with the transmitter. If other supply conditions are required please state below.
Additional Information:
Antech Reference:
Item No(s):